Sort by
Refine Your Search
-
Listed
-
Category
-
Country
-
Employer
- University of Nottingham
- Eindhoven University of Technology (TU/e)
- Faculdade de Medicina da Universidade do Porto
- UNIVERSIDAD DE LAS PALMAS DE GRAN CANARIA
- University of Sheffield;
- University of Twente
- Aalborg University
- Centre Euopéen de Recherche et de Formation Avancée en Calcul Scientifique (CERFACS)
- Cranfield University
- Grenoble INP - Institute of Engineering
- Helmholtz-Zentrum Geesthacht
- Instituto Português de Oncologia do Porto Francisco Gentil (IPO Porto)
- Instituto de Engenharia Mecânica
- Instituto de Telecomunicações
- Linköping University
- NTNU - Norwegian University of Science and Technology
- Newcastle University
- Queensland University of Technology
- Technical University of Denmark
- University of Cambridge;
- University of Inland Norway
- University of Nottingham;
- University of Oxford
- University of Oxford;
- University of Southern Denmark
- University of Stavanger
- University of Stuttgart
- University of Twente (UT)
- noma de Barcelona
- 19 more »
- « less
-
Field
-
) techniques mainly involving MEX, PBF, VPP, metal Atomic diffusion (ADAM), electrospinning, electroforming, rapid tooling and vacuum casting, as well as on polymer processing (injection moulding, compression
-
emphasis on model fine-tuning, quantization (compression / distillation), and evaluation of large language, vision, and audio models. The Gnm3 group focuses part of its research on the design, synthesis, and
-
Centre Euopéen de Recherche et de Formation Avancée en Calcul Scientifique (CERFACS) | Toulouse, Midi Pyrenees | France | about 2 months ago
requirements: MSc or equivalent in the field of Aerospace Engineering, Physics or similar Solid knowledge in Combustion, Fluid Mechanic, Compressible Turbulence and Computational Fluid Dynamics. Ability to work
-
) techniques mainly involving MEX, PBF, VPP, metal Atomic diffusion (ADAM), electrospinning, electroforming, rapid tooling and vacuum casting, as well as on polymer processing (injection moulding, compression
-
Portable Document Format (.pdf) to facilitate their reading. The files must be named with the applicant’s first and last name and must not exceed 25 MB altogether. These can be compressed in .zip format. 8
-
project. The objectives of this work are to optimize an experimental setup for simultaneous tension/compression testing and localized corrosion measurements, including monitoring of local pH and dissolved
-
cycles and rapid transient stresses (e.g., short circuits and inrush currents). Accelerated ageing experiments under compression to study long-term deformation and material degradation. Analysis of fast
-
designated with the name and surname of the candidate and must not exceed 5 MB combined. These files can be compressed into .zip format. 16.7. Failure to comply with the deadline for submission