Sort by
Refine Your Search
-
Listed
-
Category
-
Country
-
Employer
- The University of Manchester
- CNRS
- Nature Careers
- Cranfield University
- NTNU - Norwegian University of Science and Technology
- Newcastle University
- University of Warwick
- European Synchrotron Radiation Facility
- Forschungszentrum Jülich
- LEM3
- Monash University
- NTNU Norwegian University of Science and Technology
- Technical University of Denmark
- University of Greenwich
- cnrs
- Delft University of Technology (TU Delft)
- ETH Zürich
- Ecole Centrale de Lyon
- ICN2
- IRIG
- IRTA
- Imperial College London
- Institut polytechnique UniLaSalle
- Leibniz
- Luleå tekniska universitet
- Max Planck Institute for Sustainable Materials GmbH, Düsseldorf
- Max Planck Institute of Microstructure Physics •
- Pennsylvania State University
- Queensland University of Technology
- Slovak University of Agriculture in Nitra
- Stockholms universitet
- Swansea University
- UNIVERSIDAD DE BURGOS
- University of Amsterdam (UvA)
- University of Birmingham
- University of Cambridge
- University of Newcastle
- University of Sussex
- University of Twente (UT)
- Université Gustave Eiffel
- Uppsala universitet
- 31 more »
- « less
-
Field
-
microstructural defects and reduced casting reliability. Among these impurities, iron (Fe) is particularly problematic as it promotes the formation of Fe-rich intermetallic compounds, which can impair castability
-
precise control of solidification microstructures. This PhD project, building on research initiatives from the UK National Synchrotron Radiation Centre (DIAMOND Light Source project) and the German DAAD
-
or Injectpower commercializing micro solid state batteries for medical implants. Poor cycling performance of Li metal battery is due to uncontrolled Li microstructure. Fast degradation during cycling is due
-
manufacturing, yet their performance is fundamentally limited by our inability to precisely control particle alignment and microstructure during fabrication. Existing methods—such as magnetic or electric field
-
complex, three-dimensional microstructure, and understanding how that microstructure influences electrochemical performance requires methods that can bridge the scales from 3D imaging to functional
-
Consortium (CIRIMAT, Institut PPrime, Sintermat, and SafranTech) will conduct experimental work, including instrumented sintering cycles, microstructural and mechanical characterizations, industrial‑scale
-
achieve the necessary powder flow behaviour, pellet microstructure, and homogeneity. However, novel milling technologies, such as Resonant Acoustic Mixing (RAM), offer the potential for: faster and more
-
, microstructure, mechanical properties, and injectability. Conduct biological assessment, including cell viability, phenotype, ECM deposition, and immunomodulatory profiling in vitro. Contribute
-
PhD position: Nanoengineering refractory compositionally complex alloys for extreme conditions (M/F)
on the synthesis of thin films by physical vapor deposition (PVD)—including magnetron sputtering and pulsed laser deposition—at LSPM, enabling precise control of chemical composition and microstructure (grain size
-
skyscrapers, enabling early detection of damage. - Renewable Energy: Rapid, optimized design of wind turbine blades and structures for greener energy. - Microstructures: Accurate, efficient analysis of devices